Snap On 18v nicad to Milwaukee M18 adapter

Description

1 adapter that does it all!
This is a PETG 3d Printed Milwaukee M18 lithium battery to 18v Snapon Nicad tool adapter ready for use on drill(model CDR4850), 1/2" impact model(CT4850H0), flashlight(Model CTLED4918) and Sawzall.  DOES NOT WORK WITH GREASE GUN! It will NOT fit the 3850 series with battery that goes in tool.  Will NOT fit newer lithium tools.  I can't guarantee that it will fit all the Ni-cad tools, I don't own all the tools to check first. If you come across tools that it doesn't fit please contact me so I can make a list that it doesn't work with and/or adapt the adapter. (
LOCKS in place NO modifications to tools)
Pictures show the tools I own that it fits.
Complete adapter ready to rock and roll.
When using on the Heavy Impact driver the impact will not stand by itself.  It wants to fall forward. I lay my impact down on its side.  But I do include a little piece to use with the 5.0 battery so it can stand up right. In case you insist on standing your tool upright.
Must remove adapter before charging.  Only use charger made for new battery. Example Nicad/Nicad or Lithuim/Lithium  Not Lithium on Nicad charger.
Not responsible for Misuse/tool or battery damage
Do not store in above 100 degrees  example: hot car with sun beating down
For international buyer is responsible for any customs, duty,
tariff
charges.
(This does not come with batteries or tools just adapter)
Instructions:
1.  Insert tool first all the way(if the tool isn't all the way in the battery will not go in all the way)
2.  Insert battery it will need some pressure to push up the locking mechanism.  Push until the battery locks in place.
If it is really hard to push up make sure the tool is all the way in.
Tool removal:
1.  REMOVE Battery first
2.  Then remove the tool.
Very simple to operate please send me an questions or concerns so I can correct any issues that come up!  Thank you